2020 Jeep Gladiator Altitude, Automatic TransFACTORY OEM SERVICE PROCEDURE

Torque Specifications

TORQUE SPECIFICATIONS

DESCRIPTION N.m Ft. Lbs. In. Lbs. COMMENTS
A/C Condenser Bolts 5 - 45  
Belt Tensioner Bolt 50 37 -  
Block Heater Bolt 12 9 -  
Coolant Crossover Bolts 11 8 -  
Cooling Fan Bolts 8 71 -  
Coolant Recovery Bottle Bolts 10 - 89  
Left Idler Pulley Bolts 25 18 -  
Center Idler Pulley Bracket Bolts:    
M8 Bolt 25 18 -  
M10 Bolt 55 41 -  
Center Idler Pulley Bracket to Generator Bolts 24 18 -  
Center Idler Pulley Bolt 50 37 -  
Pressurized Coolant Bottle    
Bolt 5 - 44  
Nuts 10 - 89  
Right Idler Pulley Bracket Bolts 24 18 -  
Right Idler Pulley Bolt 25 18 -  
Radiator Brace Bolts 10 - 89  
Thermostat Housing Bolts 10 - 89  
Radiator to Body Bolts 11 8 -  
Water Pump Bolts:    
M6 11 8 -  
M8 23 17 -  
Transmission Fluid Cooler Tube Bracket 9 - 80  
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.