2020 Jeep Gladiator Altitude, Automatic TransFACTORY OEM SERVICE PROCEDURE

Torque Specifications

TORQUE SPECIFICATIONS

DESCRIPTION N.m Ft. Lbs. In. Lbs. Comments
Drag Link Inner Nut 39 + 125Β° 29 + 125Β° - Do not reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications.
Drag Link Outer Nut 40 + 125Β° 30 + 125Β° - Do not reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications.
Drag Link Adjuster Clamp 46 34 - Β 
Tie Rod End Nut 40 + 125Β° 30 + 125Β° - Do not reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications.
Tie Rod End Adjuster Clamp 46 34 - Β 
Steering Damper Bolt 68 50 - Do not reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications.
Steering Damper Nut 75 55 - Do not reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications.
Steering Damper Bracket Nut 75 55 - Β 
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.