Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2019 Jeep Compass Altitude, Eng CD ED6FACTORY OEM SERVICE PROCEDURE
Torque Specifications Gas Engine
TORQUE SPECIFICATIONS - GAS ENGINE
| DESCRIPTION | N.m | Ft. Lbs. | In. Lbs. | Comments |
|---|---|---|---|---|
| Accessory Drive Belt Tensioner Bolts (2.4L) | 26 | 19 | - | |
| Accessory Drive Belt Tensioner Pulley Bolt (2.4L) | 61 | 45 | - | Left-Hand Thread |
| Accessory Drive Belt Idler Pulley Bolt (2.4L) | 25 | 18 | - | |
| Engine Coolant Temperature Sensor (1.4L) | 20 | 15 | - | |
| Engine Coolant Temperature Sensor (2.4L) | 18 | 13 | - | |
| Oil Cooler Pipe Bolts | 8 | - | 71 | |
| Thermostat Housing Bolts (1.4L) | 10 | - | 89 | |
| Thermostat Housing Bolts (2.4L) | 18 | 13 | - | |
| Water Pump (1.4L) | ||||
| M6 Nut | 9 | - | 80 | |
| M6 Bolts | 9 | - | 80 | |
| Water Pump Bolts (2.4L) | 22 | 16 | - | |
| Water Pump Inlet Tube-to-Block Bolts (2.4L) | 24 | 18 | - | |
| Water Pump Inlet Tube-to-Water Pump Housing Nuts (2.4L) | 25 | 18 | - | |
| Water Pump-to-Water Pump Adapter Bolts (2.4L) | 22 | 16 | - | |
| Water Pump Pulley Bolts (2.4L) | 9 | - | 80 | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.