Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Gas Engine
When removing the radiator or A/C condenser for any reason, note the location of all radiator-to-body and radiator-to-A/C condenser rubber air seals. These are used at the top, bottom and sides of the radiator and A/C condenser. To prevent overheating, these seals must be installed to their original positions.
- Disconnect the negative battery cable.
- Remove the air cleaner body. Refer to BODY, AIR CLEANER, REMOVAL .
- Drain the cooling system. Refer to DRAININGΒ .
- Recover the A/C refrigerant. Refer to PLUMBING, STANDARD PROCEDURE .
- Remove the push pin fasteners and the right and left side air deflectors.
- Remove the nuts (3, 5) the A/C lines (2, 4) from the condenser.
- Remove the bolt securing the condenser lines to the radiator.
- On automatic transmission models, remove the bolt (1) and the transmission cooler lines (3) to the transmission cooler (4).
- Remove the coolant recover bottle hose from the radiator and the fan shroud.
- Lift up and remove the coolant recovery bottle.
- Remove the upper radiator hose (1).
- Remove the fasteners and the upper radiator upper seal (2).
- Disconnect the cooling fan wire harness connector (3).
- Remove the upper bolts for the electric cooling fan shroud from radiator.
- Remove the lower radiator hose (1).
- Lift the radiator up and out of vehicle taking care not to damage radiator fins.
- Remove the bolts (4) and the transmission cooler (5).
- Remove the bolts (3) and the A/C condenser (2) from the radiator (1).
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
