2017 Jeep Wrangler Rubicon, Automatic TransFACTORY OEM SERVICE PROCEDURE

Drive, Fan: Installation

GC0155092Courtesy of CHRYSLER GROUP, LLC
  1. Install the fan drive assembly. Tighten the bolts to 45 N.m (33 ft. lbs.).
  2. Install the serpentine belt. Refer to BELT, SERPENTINE, INSTALLATIONΒ .
  3. Install the viscous cooling fan. Refer to FAN, COOLING, INSTALLATIONΒ .
  4. Connect the negative battery cable.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.