Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Jeep Wrangler Rubicon, Automatic TransFACTORY OEM SERVICE PROCEDURE
Switch, Ignition: Installation
- Before installing ignition switch (1), rotate the slot in the switch to the ON position (2).NOTE:
Tilt arm (3) must be moved to allow installation of the switch.
- Position the switch (2) to the column and install tamper proof screw (1). Tighten screw to 2 N.m (17 in. lbs.).
- Connect the electrical connector to rear of ignition switch. Make sure that locking tab is fully seated into wiring connector.NOTE:
The ignition key must be in the key cylinder for cylinder installation. The key cylinder must be aligned with the ignition switch for installation.
- Install the lock cylinder. Refer to CYLINDER, IGNITION LOCK, INSTALLATIONΒ .
- Test the operation of the lock cylinder for smooth rotating.
- Install the multi-function switch.
- Install steering column lower cover.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
