2017 Jeep Wrangler Rubicon, Automatic TransFACTORY OEM SERVICE PROCEDURE

Steering System: Column: Removal

  1. Position front wheels straight ahead.Β 
  2. Remove and isolate the negative ground cable from the battery.
  3. Remove the airbag. Refer to AIR BAG, DRIVER, REMOVAL .
    NOTE:

    If equipped with cruise control, disconnect clock spring harness from the cruise switch harness on the steering wheel.

    GC0100893Courtesy of CHRYSLER GROUP, LLC
    1 - PULLER C-3894-A
    2 - STEERING WHEEL
  4. Remove the steering wheel (2) with puller (special tool #C-3894-A, Puller, Tie Rod) (1) or an appropriate puller

    Refer to WHEEL, STEERING, REMOVALΒ .

    GC0085651Courtesy of CHRYSLER GROUP, LLC
  5. Remove steering column opening cover. Refer to COVER, STEERING COLUMN OPENING, REMOVAL .
    GC0085652Courtesy of CHRYSLER GROUP, LLC
    1 - Upper Shroud
    2 - Lower Shroud
  6. Remove screws from the lower column shroud (2) and remove both the upper and lower shrouds.
    GC0085653Courtesy of CHRYSLER GROUP, LLC
  7. Turn ignition key to the on position.
  8. If vehicle is equipped with automatic transmission, disconnect shifter interlock cable from the column.
  9. Remove the steering coupler bolt and column mounting nuts (2) then lower column (1) off the mounting studs.
    GC0085654Courtesy of CHRYSLER GROUP, LLC
    1 - Column Wiring Harness
    2 - Multi-function Switch
    3 - Ignition Switch
    4 - Steering Column
  10. Disconnect and remove the wiring harness (1) from the column.
  11. Slide the shifter interlock cable from the tie straps.
    GC0085655Courtesy of CHRYSLER GROUP, LLC
    1 - Tilt Lever
    2 - Ignition Switch
    3 - Clockspring
    4 - Steering Column
    5 - skim/skreem
  12. Remove column (4).
  13. Transfer the necessary parts if needed.
  14. Remove clock spring (3), switches, (SKREEM if equipped) (5). Refer to CLOCKSPRING, REMOVAL .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.