Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Jeep Wrangler Rubicon, Automatic TransFACTORY OEM SERVICE PROCEDURE
Steering System: Column: Installation
| 1 - Steering Column |
| 2 - Mounting Holes |
- Align and install column (1) into the steering coupler.
1 - Column Wiring Harness 2 - Multi-function Switch 3 - Ignition Switch 4 - Steering Column - Install column harness (1) and connect harness to switches.
- Reroute the shifter interlock cable through the tie straps.
1 - Steering Column 2 - Mounting Holes - Install the column (1) onto the mounting studs (2).
- Install the two mounting nuts and the two mounting bolts all finger tight.CAUTION:
Lower nuts must be installed and tightened first then the upper nuts in order to prevent damage to the capsules.
- Tighten the lower mounting nuts to 17 N.m (150 in. lbs.).
- Tighten the upper mounting nuts to 17 N.m (150 in. lbs.).
1 - Tilt Lever 2 - Ignition Switch 3 - Clockspring 4 - Steering Column 5 - skim/skreem - Install the steering column coupler bolt and tighten to 49 N.m (36 ft. lbs.).
- Reconnect the shifter interlock cable.
- Center the clock spring (3) (if necessary) and install it on the column (4). Refer to CLOCKSPRING, INSTALLATION
.
1 - Upper Shroud 2 - Lower Shroud - Snap together the column shrouds (1AND2) and install the mounting screws.
- Install the steering column opening cover. Refer to COVER, STEERING COLUMN OPENING, INSTALLATION
.NOTE:
Do not reuse the old steering wheel bolt (a new bolt must be used)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
