2017 Jeep Grand Cherokee Laredo, AWDFACTORY OEM SERVICE PROCEDURE

Torque Specifications Diesel

Torque Specifications Diesel

DESCRIPTION N.m Ft. Lbs. In. Lbs.
Belt Tensioner Bolts 45 33 -
Belt Tensioner Bracket Bolts  
M6 11 8 -
M10 45 33 -
Block Heater Bolt 40 30 -
Coolant Inlet Tube Bolts 11 8 -
Coolant Temperature Sensor 11 8 -
Idler Pulley Bolts 32 24 -
Idler Pullet Bracket Bolts  
M6 11 8 -
M10 45 33 -
Intake Air Resonator Bolts 10 - 89
Pressurized Coolant Bottle Bolts 10 - 89
Radiator Upper Isolator to Crossmember Nuts 3 - 27
Radiator Upper Isolator to Radiator Nuts 4 - 35
Radiator Brace Bolts 10 - 89
Thermostat Housing Bolts 11 8 -
Upper Radiator Crossmember to Body Bolts 10 - 89
Vibration Damper Cover Bolts 10 - 89
Water Pump Bolts  
  25 18 -
Step 2 Loosen 90°
Step 3 32 24 -
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.