2014 Jeep Wrangler Rubicon, Automatic TransFACTORY OEM SERVICE PROCEDURE

Heater, Engine Block: Installation: Installation

Fig 1: Block Heater & Screw
GC0144482Courtesy of CHRYSLER GROUP, LLC
  1. Thoroughly clean core hole and heater seat.
  2. Insert heater (1) into the engine block.
  3. With heater seated, tighten center screw (2) securely to assure a positive seal.

    Connect power cord to heater.

    Fig 2: A/C Compressor & Mounting Bolts
    GC0153970Courtesy of CHRYSLER GROUP, LLC
  4. Position the A/C compressor (2) to the engine block. Tighten the bolts (1) to 28 N.m (21 ft. lbs.).
  5. Reconnect the A/C compressor (2) electrical connector.
    Fig 3: Drive Belt Tensioners & Assembly With Drive Belt
    GC0153982Courtesy of CHRYSLER GROUP, LLC
  6. Install the accessory drive belt.
    Fig 4: Air Cleaner Body, Fresh Air Makeup Hose, Electrical Connector, Clamp, Bolts & Retainers
    GC0154000Courtesy of CHRYSLER GROUP, LLC
  7. Install the air filter housing cover (1).
  8. Install the air intake support bolts (5).
  9. Install the air intake hose to the throttle body (4) and tighten the clamp.
  10. Reconnect the temperature sensor electrical sensor connector (3).
  11. Install the air breather tube (2).
  12. Reconnect the negative battery cable.
  13. Install the engine cover.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.