Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Jeep Compass Limited, FWDFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS TABLE
| DESCRIPTION | N.m | Ft. Lbs. | In. Lbs. |
|---|---|---|---|
| Plug, Fill | 32 | 24 | - |
| Plug, Drain | 32 | 24 | - |
| Bolts, Inspection cover | 23 | 17 | - |
| Bolts, Vent Shield | 23 | 17 | - |
| Bolts, Vent | 23 | 17 | - |
| Bolts, Output Shaft Housing | 38 | 28 | - |
| Bolts, extension housing | 38 | 28 | - |
| Nut, Output Shaft | 150 | 111 | - |
| Bolts, Carrier Assembly Side Cover | 23 | 17 | - |
| Bolts, Ring Gear | 74 | 55 | - |
| Bolt and Nut, Rear Mount Through | 75 | 55 | - |
| Bolts, Transmission Crossmember | 75 | 55 | - |
| Bolt and Nut, Transmission Crossmember through | 75 | 55 | - |
| Bolts, PTU Mounting | 58 | 43 | - |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.