2014 Jeep Compass Limited, FWDFACTORY OEM SERVICE PROCEDURE

Diesel Engine

Fig 1: Identifying Air Inlet Tube
GC0138466Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect the negative battery cable.
  2. Remove the air intake duct (2).
  3. Siphon the power steering fluid from the reservoir.
  4. Remove the fan module assembly. Refer to FAN, COOLING, REMOVALΒ .
    Fig 2: Identifying Front Upper & Lower Air Charge Hose
    GC0137799Courtesy of CHRYSLER GROUP, LLC
  5. Remove the front upper air charge hose (1).
  6. Remove the front lower air charge hose (2) to the EGR throttle control housing.
    Fig 3: Vacuum Tube Bolt
    GC0137800Courtesy of CHRYSLER GROUP, LLC
  7. Remove the brake booster vacuum line support bracket (1).
    Fig 4: Identifying Charge Air Temperature Sensor Connectors
    GC0137801Courtesy of CHRYSLER GROUP, LLC
  8. Disconnect the wire harness connector to the EGR air flow control valve and charge air temperature sensor (1).
  9. Loosen the lower hose clamp from the thermostat housing to the combination water/power steering pump.
    Fig 5: Identifying Main Drive Belt
    GC0137780Courtesy of CHRYSLER GROUP, LLC
  10. Raise the vehicle.
  11. Remove main drive belt (3). Refer to BELT, SERPENTINE, REMOVALΒ .
    Fig 6: Pressure Line At Pump
    GC0137797Courtesy of CHRYSLER GROUP, LLC
  12. Remove the water/power steering pump assembly. Refer to PUMP, WATER, REMOVALΒ .
    Fig 7: Vacuum Hose At Vacuum Pump
    GC0137802Courtesy of CHRYSLER GROUP, LLC
  13. Remove the brake booster vacuum line check valve (1) from the vacuum pump.
    Fig 8: EGR Air Flow Control Valve & Bolts
    GC0137803Courtesy of CHRYSLER GROUP, LLC
  14. Remove the four mounting screws (2) from the EGR throttle control (3) to the mixing tank.
  15. Position the inlet nozzle (1) aside, to be removed from the top side of vehicle.
  16. Remove the EGR throttle control assembly (3).
    NOTE:

    The thermostat must be replaced with the housing. Trying to remove the thermostat from the housing will damage the housing and the thermostat.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.