2014 Jeep Compass Limited, FWDFACTORY OEM SERVICE PROCEDURE

Pcm Diesel

WARNING: This page is about a different car, the 2012 Jeep Patriot and 2012 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: PCM Harness Connectors
GC0137805Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect negative battery cable.
  2. Disconnect the Powertrain Control Module (PCM) harness connectors (1).
    Fig 2: Identifying Powertrain Control Module Components
    GC0137804Courtesy of CHRYSLER GROUP, LLC
  3. Remove bolts (1) and the PCM (2) from the air cleaner housing (3).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.