2014 Jeep Compass Limited, FWDFACTORY OEM SERVICE PROCEDURE

Programming Ignition Keys To The SKREEM

WARNING: This page is about a different car, the 2009 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.

Each ignition key transponder also has a unique ID code that is assigned at the time the key is manufactured. When a key is programmed into the WCM, the transponder ID code is learned by the module and the transponder acquires the unique Secret Key ID code from the WCM. To program ignition keys into the WCM, follow the programming steps outlined in the diagnostic scan tool for PROGRAM IGNITION KEYS OR KEY FOBS  under MISCELLANEOUS FUNCTIONS  for the WIRELESS CONTROL MODULE/WCM  menu item.

NOTE: If the original keys do not successfully program to the new SKREEM after the proper procedures are followed correctly, programming new keys will be necessary.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.