Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Jeep Compass Limited, FWDFACTORY OEM SERVICE PROCEDURE
Section 147 (Electronic Control Modules (Service Information))
WARNING: This page is about a different car, the 2012 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
- Standard Procedure
- Communication
- Connector, Data Link
- Module, Anti-Lock Brake System
- Module, Compass
- Module, Final Drive Control
- Module, Glow Plug
- Module, Heated Seat
- Module, Park Assist
- Module, Power Top Control, Full Open Retractable Roof
- Module, Powertrain Control
- Module, Powertrain Control, 2.8L Diesel
- Module, Steering Column
- Module, Transmission Control
- Description
- Operation
- Standard Procedure
- TCM Quick Learn
- Drive Learn
- Notes
- Learn A Smooth 1ST Neutral To Drive Shift
- Learn A Smooth Neutral To Drive Garage Shift
- Learn The 1ST 2-3 Shift After A Restart Or Shift To Reverse
- Learn A Smooth 2-3 And 3-4 Upshift
- Learn A Smooth 4-3 COASTDOWN And Part Throttle 4-3 KICKDOWN
- Learn A Smooth 1-2 Upshift And 3-2 KICKDOWN
- Learn A Smooth Manual 2-1 PULLDOWN Shift As Well As A Neutral To Reverse Shift
- Learn A Smooth Neutral To Reverse Shift
- Learn A Smooth 4-5 Upshift
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.