Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Jeep Compass Limited, FWDFACTORY OEM SERVICE PROCEDURE
Plug, Glow: Installation: Installation
- Clean glow plug bay and install glow plug.
- Install glow plugs (1). Tighten glow plugs to 11 N.m (97 in. lbs.).
- Connect glow plug wire harness connector (1).
- Connect the glow plug four way harness connector.
- Position the wire harness (2) and push down to lock tabs (1).
- Connect the fuel rail pressure sensor harness connector (2).
- Install engine cover.
- Connect the negative battery cable.
- Install air inlet duct (2) and lock the quarter turn lock tabs (1).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.