Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Jeep Compass Limited, FWDFACTORY OEM SERVICE PROCEDURE
Charging System (Service Information): Specifications: Generator
SPECIFICATIONS TABLE
| MANUFACTURER | ENGINE | NOMINAL RATING | MINIMUM OUTPUT (AMPS) (@ SPECIFIED TEST CONDITIONS) |
|---|---|---|---|
| MITSUBISHI ELECTRIC | 1.8, 2.0, 2.4L | 120A | 70A |
| MITSUBISHI ELECTRIC | 1.8, 2.0, 2.4L | 140A | 90A |
| MITSUBISHI ELECTRIC | 2.0L TURBO DIESEL | 150A | 100A |
| TEST CONDITIONS | |||
| 1. Engine RPM : 2500 RPM (ENGINE HOT) | |||
| 2. Voltage Output : 13.0 - 16.0 V | |||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.