2014 Jeep Compass Limited, FWDFACTORY OEM SERVICE PROCEDURE

Charging System (Service Information): Generator: Removal: Diesel

Fig 1: Identifying Air Inlet Tube
GC0138466Courtesy of CHRYSLER GROUP, LLC
  1. Remove the air inlet tube (2).
    Fig 2: Identifying Bolts & Belly Pan
    GC0138465Courtesy of CHRYSLER GROUP, LLC
  2. Disconnect and isolate the negative battery cable.
  3. If equipped, remove the belly pan (2).
    Fig 3: Identifying Main Drive Belt
    GC0137780Courtesy of CHRYSLER GROUP, LLC
  4. Partially drain the radiator. Refer to STANDARD PROCEDURE .
  5. Remove the serpentine belt (3). Refer to BELT, SERPENTINE, REMOVAL .
    Fig 4: Identifying Radiator Support Shroud
    GC0138468Courtesy of CHRYSLER GROUP, LLC
  6. Remove the radiator support shroud.
    Fig 5: Identifying Hood Release Cable
    GC0138469Courtesy of CHRYSLER GROUP, LLC
  7. Disconnect the hood release cable (2).
    Fig 6: Identifying Power Steering Reservoir
    GC0138470Courtesy of CHRYSLER GROUP, LLC
  8. Remove bolt (1) and position aside the power steering reservoir (2).
    Fig 7: Upper Core Support Seal Push Pins & Radiator Core Support Bolts
    GC0137790Courtesy of CHRYSLER GROUP, LLC
  9. Remove the radiator core support.
    Fig 8: A/C Compressor-R & I
    GC0082737Courtesy of CHRYSLER GROUP, LLC
  10. Remove bolts (2) and position aside the A/C compressor (1).
    Fig 9: Identifying Upper Radiator Hose
    GC0138471Courtesy of CHRYSLER GROUP, LLC
  11. Disconnect the upper radiator hose (1) from the radiator.
    Fig 10: Identifying Electrical Connector
    GC0138472Courtesy of CHRYSLER GROUP, LLC
  12. Disconnect the generator field wire harness connector (1).
  13. Remove nut (2) and the B+ cable from the generator.
    Fig 11: Identifying Generator Mounting Retainer
    GC0138467Courtesy of CHRYSLER GROUP, LLC
  14. Remove the bottom generator mounting bolt (2).
    Fig 12: Identifying Upper Generator Mounting Bolt & Generator
    GC0138473Courtesy of CHRYSLER GROUP, LLC
  15. Remove upper bolts (2) and the generator (2).
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.