Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Jeep Compass Limited, AWD, Automatic TransFACTORY OEM SERVICE PROCEDURE
Module, Powertrain Control, 2.8L Diesel: Removal: Removal
WARNING: This page is about a different car, the 2012 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate the negative battery cable.
- Remove the glow plug relay from the powertrain control module mounting bracket (3) and position the relay aside.
- Disconnect the positive battery cable from the Totally Integrated Power Module (TIPM), remove the TIPM from the mounting bracket and position the TIPM aside. Refer to MODULE, TOTALLY INTEGRATED POWER (TIPM), REMOVAL .
- Disconnect the two harness connectors (1) from the powertrain control module (4).
- Remove the two nuts or screws (5) that secure the powertrain control module bracket to the fender (2).
- Remove the powertrain control module and bracket as an assembly from the vehicle.
- If required, remove the powertrain control module from the bracket.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
