2014 Jeep Compass Limited, AWD, Automatic TransFACTORY OEM SERVICE PROCEDURE

Module, Power Top Control, Full Open Retractable Roof: Operation: Operation

WARNING: This page is about a different car, the 2012 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.

This vehicle is available with the Full Open Retractable Roof (FORR) option. Marketed as Sky Sliderâ„¢, the unit is made of reinforced acrylic cloth, similar to a convertible top. The FORR system receives battery feed through the "sunroof" relay and a 25 amp mini fuse located in the Totally Integrated Power Module (TIPM). The FORR system power is supplied when the ignition switch is in the RUN and ACCESSORY positions. The sunroof will operate normally with the key in any position while the Accessory Delay system is active.

The FORR utilizes a single Electronic Control Unit (ECU) (sometimes referred to as the Power Top Control Module) to control the movement of the power top. The ECU sends a reference voltage to and receives inputs back from the power top switch via a hardwired connection. The ECU responds to the switch input by controlling one or both of the power top motors via a hardwired connection.

The ECU communicates via the Controller Area Network (CAN) data bus circuit and can be diagnosed and receive software updates with the use of a diagnostic scan tool. The ECU continually monitors ambient temperature and vehicle speed inputs from the instrument cluster, sometimes referred to as the Cab Compartment Node (CCN). The ECU also receives vehicle configuration data from the Totally Integrated Power Module (TIPM) to ensure proper operation related to geographical location (i.e. North American markets versus Export markets).

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.