2014 Jeep Compass Limited, AWD, Automatic TransFACTORY OEM SERVICE PROCEDURE

Switch, Ignition: Removal: Removal

WARNING:

Disconnect and isolate the battery negative (ground) cable before beginning steering wheel removal or installation. Allow the front airbag system capacitor to discharge for two minutes before removing the steering wheel or any front airbag system component. This will disable the front airbag system. Failure to disconnect the battery could result in accidental front airbag module deployment and possible personal injury.

Do not place a non-deployed airbag face down on a hard surface as the airbag will propel into the air if accidentally deployed, and could result in serious or fatal injury.

  1. Remove air cleaner fresh air duct (2) and disconnect and isolate negative battery cable at battery. Refer to BATTERY, REMOVAL .
    Fig 1: Steering Column Shrouds
    GC0083150Courtesy of CHRYSLER GROUP, LLC
  2. Remove upper (1) and lower (2) steering column shrouds. Refer to SHROUD, STEERING COLUMN, UPPER, REMOVAL and SHROUD, STEERING COLUMN, LOWER, REMOVAL .
    Fig 2: Ignition Switch Mounting Screw
    GC0083156Courtesy of CHRYSLER GROUP, LLC
  3. Position steering column to the full down position.
  4. Position ignition key to the RUN position.
  5. Disconnect the ignition switch electrical connector.
  6. Remove the ignition module mounting screw (1).
    Fig 3: Ignition Switch Removal/Installation
    GC0083157Courtesy of CHRYSLER GROUP, LLC
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.