Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2014 Jeep Compass Limited, AWD, Automatic TransFACTORY OEM SERVICE PROCEDURE

Plug, Glow: Removal: Removal

Fig 1: Quarter Turn Lock Tabs & Air Inlet Duct

Courtesy of CHRYSLER GROUP, LLC

Release quarter turn lock tabs (1) and remove air inlet duct (2).
Disconnect the negative battery cable.
Remove engine cover.

Fig 2: Identifying Fuel Rail Pressure Regulator Harness Connector
Courtesy of CHRYSLER GROUP, LLC
Disconnect the fuel rail pressure sensor harness connector (2).

Fig 3: Lock Tabs & Engine Wire Harness
Courtesy of CHRYSLER GROUP, LLC
Release the four lock tabs (1) position aside engine wire harness (2).
Disconnect the glow plug four way wire harness connector.

Fig 4: Identifying Glow Plug Harness Connectors
Courtesy of CHRYSLER GROUP, LLC
Disconnect glow plug wire harness connector (1).

Fig 5: Identifying Glow Plugs
Courtesy of CHRYSLER GROUP, LLC

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.