2014 Jeep Compass Limited, AWD, Automatic TransFACTORY OEM SERVICE PROCEDURE

Sensor, Differential Pressure: Installation: Installation

Fig 1: Identifying Bolt & Pressure Differential Sensor
GC0138495Courtesy of CHRYSLER GROUP, LLC
  1. Install pressure differential sensor (2). Tighten bolt (1) to 10 N.m (89 in. lbs.).
    Fig 2: Identifying Pressure Differential Sensor, Harness Connector & Vacuum Lines
    GC0138494Courtesy of CHRYSLER GROUP, LLC
  2. Connect the pressure differential sensor (1) vacuum lines (3).
  3. Connect the pressure differential sensor (1) harness connector (2).
  4. Connect the negative battery cable.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.