2014 Jeep Compass Limited, AWD, Automatic CVT TransFACTORY OEM SERVICE PROCEDURE

CVT Automatic Transmission (Service Information): Specifications: Specifications: Notes

CLEARANCES

DESCRIPTION SPECIFICATION
Forward clutch 1.2-1.5 mm (0.047-0.059 in.)
Total end play 0.25 - 0.55 mm (0.010 - 0.022 in)
Required differential preload 0.17 to 0.29 mm (0.007 to 0.011 in)
Required preload, Reduction gear 0.13-0.19 mm (0.005-0.0075 in)
Reduction Assembly required select shim Reduction assembly measurement, minus reduction assembly measurement, plus reduction assembly measurement, plus 0.16 mm (0.006 in).
Required clearance, Oil pump drive sprocket 0.10-0.23 mm (0.004-0.009 in.) The select shim is equal to the oil pump drive sprocket measurement one plus the oil pump drive sprocket measurement, two minus 0.16 mm (0.0065 in.).
Torque converter installed depth at least 13 mm
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.