Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Jeep Cherokee Sport, FWDFACTORY OEM SERVICE PROCEDURE
Diagnostic Test
- VERIFY THE DTC IS ACTIVE
- CHECK FOR BODY CONTROL MODULE (BCM) DTCS
- With the scan tool, read BCM DTCs.
Are there any BCM CAN Bus DTCs present?
Yes
- Perform the appropriate diagnostic procedure. Refer to the DIAGNOSTIC CODE INDEX .
No
- Go To 3
- With the scan tool, read BCM DTCs.
- CHECK FOR DRIVE TRAIN CONTROL MODULE (DTCM) CAN BUS DTCS
- With the scan tool, read DTCM DTCs.
Are there any DTCM CAN Bus DTCs present?
Yes
- Perform the appropriate diagnostic procedure. Refer to the DIAGNOSTIC CODE INDEX .
No
- Go To 4
- With the scan tool, read DTCM DTCs.
- CHECK OTHER MODULES FOR DTCS
- With the scan tool, read DTCs.
Are there any other modules reporting implausible communication DTCs against the ORC?
Yes
- Replace the Occupant Restraint Controller (ORC) in accordance with the Service Information. Refer to MODULE, OCCUPANT RESTRAINT CONTROLLER, REMOVAL .
No
- Using the schematics as a guide, check the DTCM pins, terminals, and connectors for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace the Dive Train Control Module (DTCM) in accordance with the Service Information. Refer to MODULE, DRIVETRAIN CONTROL, REMOVAL .
- Perform the DTCM VERIFICATION TEST. Refer to STANDARD PROCEDURE .
- With the scan tool, read DTCs.
- CHECK THE WIRING AND CONNECTORS
- The conditions necessary to set the DTC are not present at this time.
- Using the schematics as a guide, inspect the wiring and connectors specific to this module. Wiggle the wiring and connectors while checking for shorted and open circuits.
- Check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
- Check Service Bulletins for any possible causes that may apply.
Were there any problems found?
Yes
- Repair as necessary.
- Perform the EPS VERIFICATION TEST. Refer to STANDARD PROCEDURE .
No
- Test complete.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
