2013 Jeep Compass Limited, FWDFACTORY OEM SERVICE PROCEDURE

Power Transfer Unit (Service Information): Installation: Installation

Fig 1: Remove - Install Ptu
GC0084386Courtesy of CHRYSLER GROUP, LLC
  1. Roll the PTU in, moving from front to back (1).
    Fig 2: Ptu Install
    GC0084427Courtesy of CHRYSLER GROUP, LLC
  2. Rest the PTU (1) on the frame (3) while the engine and transaxle (2) are raised back into position.
    Fig 3: Supporting Engine With Screw Jack
    GC0084384Courtesy of CHRYSLER GROUP, LLC
  3. Lower screw jack (2) until rear mount through bolt can be installed.
    Fig 4: Rear Engine Mount
    GC0084383Courtesy of CHRYSLER GROUP, LLC
  4. Install rear mount through bolt (2) and tighten bolt to 75 Nm (55 ft. lbs.).
    Fig 5: Front Engine Mount
    GC0084428Courtesy of CHRYSLER GROUP, LLC
  5. Install the transmission crossmember and bolts, (2) tighten to 75 Nm (55 ft. lbs.).
  6. Install the through bolt at the front transmission mount (1) and tighten to 75 Nm (55 ft. lbs.).
    Fig 6: Ptu O-Ring
    GC0084429Courtesy of CHRYSLER GROUP, LLC
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.