Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Jeep Wrangler V6-3.6LFACTORY OEM SERVICE PROCEDURE
Heated Seat Module - Installation
INSTALLATION
CAUTION: Properly align the tab and retainer for the Heated Seat Module (HSM) to the holes in the instrument panel support, prior to engagement. Failure to follow these instructions may result in damage to the HSM tab and retainer.
1. Position the Heated Seat Module (HSM) (1) to the instrument panel and connect the wire harness connector (3).
2. Align the tab and push-pin retainer to the holes in the instrument panel support (2) and fully engage the retainer to the support.
3. Install the radio Radio - Installation.
4. Reconnect the negative battery cable.
5. Verify proper heated seat system operation.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
