Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2012 Jeep Wrangler Rubicon, Automatic TransFACTORY OEM SERVICE PROCEDURE

Solenoid, Variable Valve Timing: Removal: Left

Fig 1: Engine Cover

Courtesy of CHRYSLER GROUP, LLC

Disconnect and isolate the negative battery cable.
Remove the engine cover (1).

Fig 2: Throttle Body, Bolts & Connector
Courtesy of CHRYSLER GROUP, LLC
Remove the throttle body (1). Refer to THROTTLE BODY, REMOVAL .

Fig 3: Left Front Upper Intake Manifold Support Bracket & Fasteners
Courtesy of CHRYSLER GROUP, LLC
Remove two nuts (2), two bolts (3) and reposition the left front upper intake manifold support bracket (1).

Fig 4: Variable Valve Timing Solenoids, Connectors & Bolts
Courtesy of CHRYSLER GROUP, LLC

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.