Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Jeep Liberty 2WD V6-3.7LFACTORY OEM SERVICE PROCEDURE
Connecting Rod, Engine
CONNECTING ROD, ENGINE
Tighten connecting rod cap and bearing 27 Nm (20 ft. lbs.) plus 90°
CONNECTING ROD
Side Clearance 0.10 - 0.35 mm (0.004 - 0.0138 in.)
Bearing Bore Out of Round (MAX) 0.004 mm (0.0002 in.)
CONNECTING ROD JOURNALS
Connecting Rod Journal Diameter 57.908 - 57.892 mm (2.2798 - 2.2792 in.)
Out of Round (MAX) 0.005 mm (0.0002 in.)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.