2012 Jeep Grand Cherokee Laredo, AWDFACTORY OEM SERVICE PROCEDURE

Heater, Engine Block: Installation: 3.6L

Fig 1: 3.6L Engine Block Heater & Cylinder Block
GC0144482Courtesy of CHRYSLER GROUP, LLC
  1. Clean block core hole and heater seat.
  2. Insert heater block (1) assembly.
  3. With block heater seated, tighten screw (2) to 12N.M (106 in.lbs.) to assure a positive seal.
  4. Install power cord plug to block heater (1).
  5. Fill cooling system with coolant to the proper level. Refer to STANDARD PROCEDUREΒ .
    Fig 2: A/C Compressor
    GC0145963Courtesy of CHRYSLER GROUP, LLC
  6. Install the A/C compressor. Refer to COMPRESSOR, A/C, INSTALLATION .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.