Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Jeep Compass Latitude, 2.0 AFACTORY OEM SERVICE PROCEDURE
Diagnostic Code Index
WARNING: This page is about a different car, the 2016 Dodge Charger and 2015 Dodge Charger. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC CODE INDEX
| DTC | Description |
|---|---|
| B1612-12 | PANEL ILLUMINATION CONTROL - CIRCUIT SHORT TO BATTERY |
| B1692-11 | ACCESSORY DIMMING CONTROL - CIRCUIT SHORT TO GROUND |
| B1692-12 | ACCESSORY DIMMING CONTROL - CIRCUIT SHORT TO BATTERY |
| B1812-12 | PASSENGER DOOR AJAR - CIRCUIT SHORT TO BATTERY |
| B1815-12 | REAR DRIVER DOOR AJAR - CIRCUIT SHORT TO BATTERY |
| B1818-12 | REAR PASSENGER DOOR AJAR - CIRCUIT SHORT TO BATTERY |
| B19B3-11 | DRIVER DOOR AJAR OUTPUT - CIRCUIT SHORT TO GROUND |
| B2121-12 | IGNITION RUN CONTROL 1 - CIRCUIT SHORT TO BATTERY |
| B215F-12 | IGNITION ACCESSORY 1 CONTROL - CIRCUIT SHORT TO BATTERY |
| B287B-12 | LEFT REAR WIG WAG LIGHTS - CIRCUIT SHORT TO BATTERY |
| B287C-12 | RIGHT REAR WIG WAG LIGHTS - CIRCUIT SHORT TO BATTERY |
| B22A9-00 | ECU INTERNAL PERFORMANCE |
| C10CB-11 | VEHICLE SPEED OUTPUT - CIRCUIT SHORT TO GROUND |
| C10CB-12 | VEHICLE SPEED OUTPUT - CIRCUIT SHORT TO BATTERY |
| U0064-00 | VSIM UPFITTER BUS |
| U0065-00 | VSIM UPFITTER BUS OFF PERFORMANCE |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.