2012 Jeep Compass 2WD L4-2.4LFACTORY OEM SERVICE PROCEDURE

Front






FRONT SOLENOID 1/1

Factory service manual diagram




1. Solenoid for front location 1/1. Note mounting tab location is different between front and rear solenoids.

Factory service manual diagram




2. Install solenoid into cylinder head.
3. Install mounting bolt and tighten to 12 Nm (9 ft. lbs.).

Factory service manual diagram




4. Install oil pressure sensor.
5. Connect electrical connector to oil pressure sensor.
6. Connect electrical connector to Variable valve timing solenoid.
7. Connect negative battery cable.
8. Install engine cover.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.