Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Jeep Compass 2WD L4-2.4LFACTORY OEM SERVICE PROCEDURE
Infrared Temperature Sensor - Removal
REMOVAL
NOTE: Take the proper precautions to protect the front face of the overhead console from cosmetic damage while performing this procedure.
1. Disconnect and isolate the negative battery cable.
2. Remove the overhead console (4) from the headliner and place it on a workbench.
3. Remove the screw (1) that secures the infrared sensor (3) to the back of the overhead console.
4. Disengage the infrared sensor from the retaining tabs (2) on the overhead console and remove the sensor.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.