Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2011WRANGLER V6-3.8LREPAIR AND DIAGNOSISSTARTING AND CHARGINGBATTERYBATTERY CONTROL MODULESERVICE AND REPAIRINTELLIGENT BATTERY SENSOR (IBS) - REMOVAL
2011 Jeep Wrangler V6-3.8L
Intelligent Battery Sensor (IBS) - Removal
2011 Jeep Wrangler V6-3.8LSECTION Intelligent Battery Sensor (IBS) - Removal
REMOVAL
1. Remove the negative battery cable retainer (1).
2. Remove the negative battery cable (2) from the Intelligent Battery Sensor (IBS) (5).
3. Disconnect the harness connector from the IBS (3).
WARNING: Do not remove the captive nut, doing so will cause the stud to break.
4. Loosen the captive nut (4).
5. Remove the IBS sensor (5) from the battery.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.