Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSJEEP2011WRANGLER V6-3.8LREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSFLYWHEEL

2011 Jeep Wrangler V6-3.8L

Flywheel

2011 Jeep Wrangler V6-3.8LSECTION Flywheel

FLYWHEEL

Install flywheel with new bolts and tighten in a criss-cross pattern.
Tighten bolts 50 Nm (37 ft. lbs.).

Using a torque wrench fitted with a Torque Angle Gauge, (Goniometer), loosen one flywheel bolt at a time.
tighten 25 Nm (19 ft. lbs.) plus angle in relation to bolt length.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.