Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Sensor, Intrusion Module: Removal: Console
An intrusion sensor is installed within the center floor console only on four-door vehicles equipped with the export premium version of the Vehicle Theft Alarm (VTA).
- Disconnect and isolate the battery negative cable.
- Remove the center console from the vehicle. Refer to CONSOLE, CENTER, REMOVAL .
- Place the center console on a suitable work surface. Be certain to take the proper precautions to protect the console from receiving cosmetic damage during the service procedure.
- Remove the screws at each rear side of the console that secure the rear trim cover to the console.
- Remove the rear trim cover from the console.
- Remove the fasteners securing the intrusion sensor to the rear outer surface of the center console bin.
- Remove the intrusion sensor from the center console bin.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.