Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2011LIBERTY RENEGADE, PART TIMEREPAIR AND DIAGNOSISTRANSMISSIONTRANSMISSION CONTROL SYSTEMS(TRANSMISSION CONTROL MODULE (TCM) - ELECTRICAL DIAGNOSTICS)DTC TROUBLESHOOTINGP0614-ECM/TCM INCOMPATIBLEDIAGNOSTIC TEST
2011 Jeep Liberty Renegade, Part Time
Diagnostic Test
2011 Jeep Liberty Renegade, Part TimeSECTION Diagnostic Test
- CHECK IF TCM IS FLASHABLE
- With the scan tool, record the vehicles TCM and PCM/ECM part numbers.
- Verify the model year and make of both the TCM and ECM/PCM part numbers.
- Flash and program the controller(s) with the correct software that corresponds with year and make of the vehicle.
Were you able to update (flash) the controller(s) successfully to the proper software levels?
Yes
- Test Complete.
- Perform the NAG1 TRANSMISSION VERIFICATION TEST. Refer to Standard Procedure .
No
- Using the schematics as a guide, check the Transmission Control Module (TCM) terminals for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace and program the TCM in accordance with the Service Information.
- Perform the NAG1 TRANSMISSION VERIFICATION TEST. Refer to Standard Procedure .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.