Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2011LIBERTY 4WD V6-3.7LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSENGINE CONTROL MODULESERVICE AND REPAIRPOWERTRAIN CONTROL MODULE - INSTALLATION
2011 Jeep Liberty 4WD V6-3.7L
Powertrain Control Module - Installation
2011 Jeep Liberty 4WD V6-3.7LSECTION Powertrain Control Module - Installation
INSTALLATION
NOTE: Right hand drive PCM is in a different location (shown below).
1. The PCM (Powertrain Control Module) (3-Left Hand Drive), or (3-Right Hand Drive) is located in the engine compartment.
2. Position PCM (3-Left Hand Drive), or (3-Right Hand Drive) to vehicle.
3. Install PCM mounting screws (5-Left Hand Drive), or (4-Right Hand Drive). Tighten screws to 8 Nm (71 in. lbs.) torque.
4. Connect PCM electrical connectors (4-Left Hand Drive), or (5-Right Hand Drive).
5. Connect negative battery cable.
CAUTION: Refer to PCM/ECM REPROGRAMMING for reprogramming procedures. If this step is not performed, a Diagnostic Trouble Code (DTC) will be set. Programming and Relearning
CAUTION: Use the scan tool to reprogram the new PCM with the vehicles original identification number (VIN) and the vehicles original mileage. If this step is not performed, a Diagnostic Trouble Code (DTC) will be set.
Right hand drive location:
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.