Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2011GRAND CHEROKEE 4WD V6-3.6LREPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTANTITHEFT AND ALARM SYSTEMSKEYLESS ENTRYKEYLESS ENTRY MODULESERVICE AND REPAIRPASSIVE ENTRY MODULE - REMOVAL
2011 Jeep Grand Cherokee 4WD V6-3.6L
Passive Entry Module - Removal
2011 Jeep Grand Cherokee 4WD V6-3.6LSECTION Passive Entry Module - Removal
REMOVAL
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.
1. Disconnect and isolate the battery negative cable.
2. If the vehicle is so equipped, remove the closeout (hush) panel from under the passenger side end of the instrument panel. Instrument Panel - Removal.
3. From the passenger side of the vehicle, reach around the outboard end of the heater and air conditioner blower housing (1) to access and disconnect the two instrument panel wire harness connectors from the two Passive Entry Module (PEM) (2) connector receptacles (3).
4. Remove the three screws (4) that secure the PEM to the tabs on the blower housing.
5. Remove the PEM from the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.