Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2011GRAND CHEROKEE 2WD V8-5.7LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSFUEL LEVEL SENSORSERVICE AND REPAIRFUEL LEVEL SENDING UNIT AND SENSOR - INSTALLATION
2011 Jeep Grand Cherokee 2WD V8-5.7L
Fuel Level Sending Unit And Sensor - Installation
2011 Jeep Grand Cherokee 2WD V8-5.7LSECTION Fuel Level Sending Unit And Sensor - Installation
INSTALLATION
1. Position the fuel level sending unit to the fuel pump module, slide unit on mounting track until the plastic locking tab (3) snaps into position.
2. Route the fuel level sending unit wires into the retaining tabs (1,2) on the fuel pump module.
3. Connect the fuel level sending unit electrical connectors (1,2) to the fuel pump module.
4. Install the main fuel pump module Fuel Tank - Installation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.