Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2011GRAND CHEROKEE 2WD V6-3.6LREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSBODY AND FRAMESYSTEM SPECIFICATIONSWELD PROCESS
2011 Jeep Grand Cherokee 2WD V6-3.6L
Weld Process
2011 Jeep Grand Cherokee 2WD V6-3.6LSECTION Weld Process
WELD PROCESS
These Procedure Specifications are appropriate as of this publication. Procedures may be superceeded with new spec's at a later date.
Always process to the thinner material thickness (TMT)
All persons performing welding must be qualified to weld in all positions.
NOTE:
1. Must remove Zinc Coating on both sides of metal at the weld zone.
2. MIG Braze welding process requires use of Pulse Arc(R) or STT(R) welding machine.
3. Must use Lincoln(R) product since E 71T-11 product differs from other suppliers.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.