Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Jeep Compass Limited, FWD, StandardFACTORY OEM SERVICE PROCEDURE
Gas Engine
| 1 - MOUNTING BRACKET |
| 2 - BOLT |
| 3 - RADIATOR HOSE TEE |
| 4 - WASHER RESERVOIR |
| 5 - HOSE |
| 6 - COOLANT RECOVERY CONTAINER |
- Position the coolant recovery container (6) into the washer fluid reservoir (4).
- Install the coolant recovery container mounting bolt (2). Tighten the mounting bolt to 4 N.m (35 in. lbs.).
- Connect the hose (5) at the upper radiator tee (3).
- Fill coolant recovery container to proper level. Refer to Standard ProcedureΒ .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
