Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2011COMPASS LIMITED, FWD, STANDARDREPAIR AND DIAGNOSISELECTRICALBODY ELECTRICALPOWER DISTRIBUTIONOUTLET, POWERINSTALLATIONINSTALLATION
2011 Jeep Compass Limited, FWD, Standard
OUTLET, Power: Installation: Installation
2011 Jeep Compass Limited, FWD, StandardSECTION Installation
- Position mount ring to the instrument panel and feed the wires through ring. Index the cap and the mount ring with the index tab at 9 o'clock to the key in the instrument panel. Install the ring.
- Connect wires to base. Orient base alignment rib at 11 o'clock to mate the groove in mount ring at the same location.
- Push base into the bezel till it locks.
- Install cigar lighter cap.
- Connect the battery negative cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.