Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2011COMPASS BASE, 2.0 A, STANDARDREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSENGINE COOLING SYSTEMENGINESENSOR, COOLANT TEMPERATUREINSTALLATIONDIESEL ENGINE
2011 Jeep Compass Base, 2.0 A, Standard
Diesel Engine
2011 Jeep Compass Base, 2.0 A, StandardSECTION Diesel Engine
| 1 - FUEL RAIL |
| 2 - EGR VALVE |
| 3 - POWER STEERING PUMP |
| 4 - GENERATOR |
| 5 - COOLANT TEMPERATURE SENSOR |
| 6 - THERMOSTAT HOUSING |
| 7 - FUEL RAIL PRESSURE SENSOR |
- Position and install coolant temperature sensor (5).
- Connect coolant temperature sensor electrical connector.
1 - RETAINING CLAMP 2 - ENGINE COOLANT TEMPERATURE SENSOR - Refill coolant system to proper level with proper mixture of coolant. Refer to Standard Procedure .
- Install engine cover.
- Connect negative battery cable.WARNING:
Use extreme caution when engine is operating. Do not stand in a direct line with fan. Do not put your hands near pulleys, belts or fan. Do not wear loose clothes.
- Start engine and inspect for leaks.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.