Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2011COMPASS BASE, 2.0 A, STANDARDREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSENGINE COOLING SYSTEMENGINEPUMP, WATERREMOVALGAS ENGINE
2011 Jeep Compass Base, 2.0 A, Standard
Gas Engine
2011 Jeep Compass Base, 2.0 A, StandardSECTION Gas Engine
| 1 - WATER PUMP |
| 2 - MOUNTING BOLT |
| 3 - WATER INLET TUBE NUTS |
| 4 - INLET WATER TUBE |
- Remove the accessory drive belt. Refer to BELT, Serpentine, Removal .
- Raise vehicle. Refer to Hoisting, Standard Procedure .
- Remove accessory drive belt splash shield.
- Drain cooling system. Refer to Standard Procedure .
- Remove screws attaching water pump pulley (1). Remove pulley (1).
- Remove water pump mounting bolts (2).
- Remove water pump (3).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.