SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2011COMPASS BASE, 2.0 A, STANDARDREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSENGINE COOLING SYSTEMENGINEFAN, COOLINGINSTALLATIONDIESEL 2.2L - INSTALLATION
2011 Jeep Compass Base, 2.0 A, Standard

Diesel 2.2L - Installation

2011 Jeep Compass Base, 2.0 A, StandardSECTION Diesel 2.2L - Installation
Fig 1: Lower, Fan Blade Retaining Nut & Fan Motor
GC0137791Courtesy of CHRYSLER LLC
  1. Install the fan motor (5) onto shroud (3).
  2. Install the fan (6) onto the motor.
  3. Install the lower (8) shroud seal.
    Fig 2: Radiator Fan Assembly
    GC0083982Courtesy of CHRYSLER LLC
  4. Install radiator fan module (1).
  5. Connect the electrical connectors.
  6. Install upper radiator hose.
  7. Install the wiring harness mounting retainers into fan shroud.
    Fig 3: Upper Core Support Seal Push Pins & Radiator Core Support Bolts
    GC0137790Courtesy of CHRYSLER LLC
  8. Install the upper radiator core support. Tighten outer bolts (1) to 23 N.m (17 ft. lbs.). Tighten the inner support bolts (1) to 8 N.m (6 ft. lbs.).
  9. Install the hood latch cable.
  10. Install the core support seal (3).
    Fig 4: Power Steering Fluid Reservoir & Mounting Bolt
    GC0137789Courtesy of CHRYSLER LLC
  11. Install the power steering reservoir (2). Tighten bolt (1) to 12 N.m (9 in. lbs.).
    Fig 5: Identifying Upper Radiator Closure Panel
    GC0137788Courtesy of CHRYSLER LLC
  12. Install radiator closure panel (2). Refer to PANEL, Closure, Upper, Installation .
  13. Top coolant off. Refer to Standard Procedure .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.