Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2011COMPASS BASE, 2.0 A, STANDARDREPAIR AND DIAGNOSISENGINE PERFORMANCEIGNITION SYSTEM (SERVICE INFORMATION)SPARK PLUGREMOVALREMOVAL
2011 Jeep Compass Base, 2.0 A, Standard
Spark Plug: Removal: Removal
2011 Jeep Compass Base, 2.0 A, StandardSECTION Removal
- Disconnect the negative battery cable.
- Disconnect the electrical connectors from ignition coils.
- Remove the ignition coil mounting bolt.
- Twist the ignition coil then pull straight up.
- Remove the spark plug using a quality socket with a rubber or foam insert.
- Inspect the spark plug condition.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.