Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2011COMPASS 4WD L4-2.4LREPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINTRANSFER CASESERVICE AND REPAIRPROCEDURES
2011 Jeep Compass 4WD L4-2.4L
Procedures
2011 Jeep Compass 4WD L4-2.4LSECTION Procedures
DRAIN AND FILL
Special Tools:
1. If fluid level is low or fluid change is required fill with MOPAR(R) MS SAE 80W90 Gear Lube until to bottom of fill plug.
2. Tighten fill plug (1) to 32 Nm (24 ft.lbs.).
3. Tighten drain plug (2) to 32 Nm (24 ft.lbs.).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.