Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2011COMPASS 4WD L4-2.4LREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINECRANKSHAFT MAIN BEARING
2011 Jeep Compass 4WD L4-2.4L
Crankshaft Main Bearing
2011 Jeep Compass 4WD L4-2.4LSECTION Crankshaft Main Bearing
CRANKSHAFT MAIN BEARING
Tighten bolts marked with b or 6 using the following three step method, in the sequence shown:
Tighten all bolts 15 Nm (11 ft. lbs.)
Tighten all bolts 27 Nm (20 ft. lbs.)
Tighten all bolts additional 45°.
Tighten bolts marked with M using the following three step method, in the sequence shown:
Tighten all bolts 15 Nm (11 ft. lbs.)
Tighten all bolts 45 Nm (33 ft. lbs.)
Tighten all bolts additional 45°.
Main Bearing Diametrical Clearance 0.028 - 0.048 mm (0.0011 - 0.0018 in.)
Main Bearing Diametrical Clearance (Max) (0.058 mm 90.0022 in.)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.