SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2011COMPASS 4WD L4-2.4LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSCRANKSHAFT POSITION SENSORSERVICE AND REPAIRCRANKSHAFT POSITION SENSOR - INSTALLATION
2011 Jeep Compass 4WD L4-2.4L

Crankshaft Position Sensor - Installation

2011 Jeep Compass 4WD L4-2.4LSECTION Crankshaft Position Sensor - Installation





INSTALLATION





1. Check O-ring for damage and lubricate the O-ring with engine oil before installing sensor.
2. Using a twisting motion, install the crankshaft position sensor.
3. Install the crankshaft position sensor bolt. Tighten the bolt to 9 Nm (80 in. lbs.).





4. Connect and lock the electrical connector to the crankshaft position sensor.





5. Install the heat shield (3) with one nut (1) and two heat shield retaining bolts (2).





6. Install the upstream O2 sensor wire harness retainer (1) and crankshaft position sensor wire harness retainer (2) to the heat shield (3).





7. Install the air cleaner body (1) Air Cleaner Body - Installation





8. Connect the negative battery cable.
9. Install the engine cover (1).

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.